blob: 95f6c1b83865b0b244c15aad86d092d9be3a5f62 [file] [log] [blame] [raw]
Known problems/bugs:
- GRUB cannot boot any uncommon format of floppies, such as 1.68MB.
Perhaps we should add support to embed a fixed geometry in a drive.
- GRUB cannot boot FreeBSD 3.4 and 4.0 directly. So you must
chain-load them instead.
- FreeBSD boot command-line options are slightly problematic, and
OpenBSD options are probably quite wrong. This is because they
use options that are bits in a data word passed at boot time, and
the developers change the encoding sometimes. Will re-sync in a later
release.
- If an "uppermem" command was used to tell GRUB it had a different
amount of upper memory available, then the user escapes to the menu
interface, the upper memory displayed there still says the amount
set by the user instead of being reset to the default by the escape.
It actually resets when the next command-line is entered or config
file entry is executed.
- There is at least one problem when using an "install_partition" that is
a BSD sub-partition where the PC partition isn't explicit (i.e.
the default 0xFF00FF is a problem)... this is when using "makeactive"
without explicitly setting the root partition. If this is done, a
"no such partition" error will be generated.
- Cannot boot FreeBSD "kzip"ed image. Use a normal kernel (using GRUB's
automatic "gzip" decompression works fine).
- Hitting Ctrl-Alt-Delete when in GRUB locks some machines. Use Reset
for now. (This apparently hasn't been observed for a while)